Table 5-1. Error Codes 
ERROR NUMBER EXPLANATION 
  1. The object code for user program has exceeded the available RAM for storage of object code for that device type (see Section 2.11). 
  2. Unable to AORG at location specified due to RAM limits (see Section 2.11). 
  5. Mnemonic entered not found in TMS7000 instruction set. 
 15. Expression is not proper for the specified TMS7000 instruction. 
 17. Not a printable character. 
 20. Expected a character A-Z, did not receive. 
 25. Register/peripheral value greater than 255. 
 30. Comma expected but was not found. 
 35. Premature <CR> detected. 
 40. Duplicate label definition. 
 60. Operand should be an absolute address or a label equating to an absolute address. 
 70. <CR> detected as first character in mnemonic field. 
 80. Greater than 6 characters in label. 
200. Operand must be Register A, Register B, a register number (RO-R255), or a label equating to a register. In the case of a PUSH or POP command the operand may also be ST (Status Register). 
203. Jump displacement too large (acceptable values are -128 to +127). 
205. Operand must be Register A, Register B, a register number (RO-R255), or a label equating to a register. 
207. Addressing must be direct, indirect, or indexed. 
208. TRAP number must be less than 24. 
209. The operand source must be Register A, Register B, a register number (RO-R255), a label equating to a register, or an absolute value. 
210. If the operand source is Register A then the destination must be Register B, a register number (RO-R255), or a label equating to a register. If the operand source is Register B then the destination must be Register A, a register number (RO-R255), or a label equating to a register.
212. The operand source must be Register A, Register B, a register number (RO-R255), or a label equating to a register. 
219. The operand source must be Register A, Register B, or an absolute value: If the instruction is MOVP then the operand source may also be a peripheral register (PO-P255) or a label equating to a peripheral register: 
220. The operand destination must be a peripheral register. 
223. The operand destination must be Register A or Register B. 
224. Improper format in the operand. 
245. Index register must be Register B. 
254. Format is improper for an equate statement.